1001548, FullForce RC Adjustable Sway Bar Mounts (HPI Baja 5b / 5T / 5SC) 4pcs.

€28,90


1001548, FullForce RC Adjustable Sway Bar Mounts (HPI Baja 5b / 5T / 5SC) 4pcs.

The only adjustable rear swaybar mounts on the market!
We did a bit of engineering with this one, trying to figure out a way to get a little bit more adjustability out of a simple mount.
These new mounts give you two parallel positions and allow you to "angle" your swaybar for the ultimate performance on the road or an oval track!

BAJA REAR SWAYBAR MOUNT INSTALL

-Contests of kit include 2 machined AL sway bar mounts, 6 machined AL cone washers, 2-M3x25 flat socket screws, 4-M3x8 flat socket screws & 2-M3x4 socket set screws.
-First remove the weak stock plastic sway bar mounts. Verify that the two M3 locknuts are still in place inside the rear bulkhead.
-Snap the two new aluminum sway bar mounts in place as in picture above.
They will be tight fitting on the stock plastic.
-If needed, use the four small M3x4 socket set screws on the inside of the slots as shown (Make sure to use loctite on these little set screws).
These prevent vibration and noise when using the medium and small sway bar size wires.
You do not need to use these if running the thick sway bar wire.
-Now chose the position you would like to mount the sway bar wire in.
You can use the upper or lower mounting position or you can use the angled position if you use the medium or small size wire.
The large wire will not bend for the angled install.
-Use one cone washer for every screw starting with the two M3x25 screws in the upper holes, then the four M3x8 screws in the lower holes.
-That's it. You're done! Just remember, use loctite!

DDM part Nr: TR997.

If you do not want to or can not assemble this set / part bij yourself, we will gladly do it for you. Please contact us without obligation.

Product niet op voorraad!

Reviews